97 EK hatch

I thought you were going with a RHD clip? either way, i'm jealous. You can actually do work on yours...

Yes the RHD will be what I end up with but the money is far more than I can afford at the time and the car would have to sit for long time while I saved up for it. Should find out this week about getting it emission tested. Debating on going to Import Face-Off here in Tuscon next month, the guys at BWR invited me to head out there.

Right on man, hope you can get it registered. IFO came to Oregon for the first time a couple years back and came back this year but I had to work, totally regret not askin for the day off after seeing the pictures the next day. I say definitely go.

Debating on if I want to make the drive, it's only like 2 hours. I guess if I can get my car registered in time then I might just do it. Not too big into drag racing though so just go for the other events I guess and to see some nice cars.

I wish we had something like that here. Maybe one day i can start a modified car club...

Just ordered a new intake for the hatch this morning and should be getting it next week I hope. Went with the PasswordJDM power chamber and I am soo excited.

Pretty slick. I might have to get one for my turbocharged Eclipse. lol

Niiiice. I want some of their Kevlar parts like the spark plug wire cover for my h22.

Yeah totally. Once i get the new motor I'm definitely going to get a few CF pieces.

Eventually I will have some more carbon pieces to add to my car. Would like to get a Carbon hatch, roof, airbag delete tray, quick release, and someday be able to afford some carbon Bride racing seats.

Dminted wrote:Finally got my new valve cover washers from Password:JDM and I love them.

How did you get the top two valve screws on the valve cover? I cannot figure it out

It was a little difficult but put those ones in first and connect the screw to the post and then put the cover on and screw down the post to head. It took me a little trial and error when putting them on and had to try a few different ways. good luck with it man they look great once on.

Might get me some once i get the new motor. Got a whole list of stuff planned. Taking a few leaves out of your book bro. lol

Definitely gonna pick up a set.. Might go with skunk2, theirs are lower profile.

I saw the low profile ones but I liked these ones better. Should of got some BWR ones but I didn't know they were so close when I got them.

What do black works ones look like? Might check those out. Got a pic?

Well looks like they don't have the VC bolts yet but they do have the fender washers. Just a generic washer, will have to talk to them about making VC bolts.

Yeah I'm dropping thousands on skunk2 parts and shooting for acceptance on their street team so i'll probably just buy theirs.

Yeah if you can get in with them that would be cool. I have been doing some networking with BWR now and have been trying to get in good with them cause they have hookups everywhere, and they are just a few miles from me so it's super easy to just cruise down and check out whats going on.

Had some issues with payment on the air intake, the company had the wrong PayPal account listed so I had to cancel it and wait for the money to go back into my account and send them the payment again. Should have had it this week but now I'm looking at next week.

I'll have to get some for my engine. Too bad about the intake. Did you see Street Obsessions' post about a group buy on a carbon fibre intake? sounds kinda mean...

Yeah that is for the manifold though, I got it all squared away and the intake will be sent out shortly just took some waiting for money to transfer.

Sounds cool. Too bad it's a freaking thousand dollars.

Just got my PasswordJDM intake in today, love it!!!!!

That's freaking cool man. Wish they made one for my car. how much did that set you back?